Crank angle sensor wire color? Ka24de - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Ritz S14 · 04-13-2005, 12:29 PM

I have a 93 ka24de, and I need to know the wire colors for the crank angle sensor.

I have a few service manuals, but it doens't have the color, nor does it list if it's 1degree or 180degrees.

Once again I need the colors for the 1degree mark and the 180degree mark.

Thanks in advance.

Ritz S14 · 04-13-2005, 12:49 PM

Ok. Found this pic

I'm assuming since the black and the white wire are shielded, they must be the 1degree and 180 degree mark correct?

Ritz S14 · 04-16-2005, 12:24 PM

For those of you who ever plan to install a BEE*R Rev limiter on your s14
Red is ignition
Black is ground
White(optional)-ebrake switch
The brown loop wire is cut for 4cylinder, looped for 6.
Yellow-pin 44/40 is your reference signal(1degree)
Green-41/45 is your 180degree signal.

This was on my s13, I revved the crap out of the motor and the headgasket took a sh1t. So it'll be installed on my s14.

04-13-2005, 12:29 PM	#1
Ritz S14 Post Whore! Join Date: Jul 2004 Location: C A L I F O R N I A Age: 42 Posts: 3,586 Trader Rating: (0) Feedback Score: 0 reviews	Crank angle sensor wire color? Ka24de I have a 93 ka24de, and I need to know the wire colors for the crank angle sensor. I have a few service manuals, but it doens't have the color, nor does it list if it's 1degree or 180degrees. Once again I need the colors for the 1degree mark and the 180degree mark. Thanks in advance.

04-13-2005, 12:49 PM	#2
Ritz S14 Post Whore! Join Date: Jul 2004 Location: C A L I F O R N I A Age: 42 Posts: 3,586 Trader Rating: (0) Feedback Score: 0 reviews	Ok. Found this pic I'm assuming since the black and the white wire are shielded, they must be the 1degree and 180 degree mark correct?

04-16-2005, 12:24 PM	#3
Ritz S14 Post Whore! Join Date: Jul 2004 Location: C A L I F O R N I A Age: 42 Posts: 3,586 Trader Rating: (0) Feedback Score: 0 reviews	For those of you who ever plan to install a BEE*R Rev limiter on your s14 Red is ignition Black is ground White(optional)-ebrake switch The brown loop wire is cut for 4cylinder, looped for 6. Yellow-pin 44/40 is your reference signal(1degree) Green-41/45 is your 180degree signal. This was on my s13, I revved the crap out of the motor and the headgasket took a sh1t. So it'll be installed on my s14.