Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - finally Ka-t installed....but not running right???

Realnez · 11-02-2006, 10:45 PM

hey everyone I finally turbo'd my DOHC KA in my s13, Im running sr injectors, fmic, T25 and SAFC2,N60 MAF (blowthrew setup mounted by the TB). I finally got it in and shes starting up but its idling very weird. First off my idle says above 2000RPM and doesn't want to come down. Secondly when I touch the throttle is stumbles etc. Im going to try a different vaccume source because I tapped into a line that used to go into the air intake (Im a noob). Also I noticed a bit of smoke comming from the turbo, is it just burning the excess crap off?? Its a T25 with oil and coolent lines and I only have the oil lines hooked up. I will post up a vid of the problem in the next about 20 mins, does anyone know where to tap in the vaccume line? LMK asap I need my car to get to work tomorrow haha.

Safc 2 Settings

HW In 2 out 5

All settings are on 0% because I had it in while N/A (I dont know what to set it too)

thanks
James

11-02-2006, 10:45 PM	#1
Realnez Zilvia Junkie Join Date: Jan 2006 Location: Burnaby Posts: 322 Trader Rating: (0)	finally Ka-t installed....but not running right??? hey everyone I finally turbo'd my DOHC KA in my s13, Im running sr injectors, fmic, T25 and SAFC2,N60 MAF (blowthrew setup mounted by the TB). I finally got it in and shes starting up but its idling very weird. First off my idle says above 2000RPM and doesn't want to come down. Secondly when I touch the throttle is stumbles etc. Im going to try a different vaccume source because I tapped into a line that used to go into the air intake (Im a noob). Also I noticed a bit of smoke comming from the turbo, is it just burning the excess crap off?? Its a T25 with oil and coolent lines and I only have the oil lines hooked up. I will post up a vid of the problem in the next about 20 mins, does anyone know where to tap in the vaccume line? LMK asap I need my car to get to work tomorrow haha. Safc 2 Settings HW In 2 out 5 All settings are on 0% because I had it in while N/A (I dont know what to set it too) thanks James __________________