Quote:
|
Originally Posted by nrg
1: waste of time. good in the long run if you're going to change out to braided lines and not use that water line. But i'm sure he's going to keep the turbo setup how it is.
2: what for? i've done plenty of swaps and never needed to do this. 5/8 hosing fits, it's just a very tight fit.
|
Everybody has their own way of doing it. 2 minutes with a welder can save some hassle once the motor is installed.
Stretching 5/8" ID hoses to a 3/4" OD fitting may cause the hose to rupture over time if you're using cheap hoses.
I love cheap hose though
