Thread: How much clerance do you run on you MAIN's and ROD bearings ?
View Single Post
Old 12-11-2007, 03:04 PM   #21
RedtopTech
Zilvia Member
 
RedtopTech's Avatar
 
Join Date: Dec 2005
Location: Virginia Beach, VA
Age: 40
Posts: 293
Trader Rating: (0)
RedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud of
tight side of factory spec! how many times does it need to be said? there isnt any single magic #. The factory gives you an operating range spec, stay within spec. These are the best clearances for engine life and performance. Youre making big power and high rpm- you need good oil pressure, keep it tight!
RedtopTech is offline   Reply With Quote