[gschroeder78]

Ha! I wish I took pictures. Anyways, I only had manual mirrors but I did study the power stuff because I was supposed to get new doors with all the power stuff in them. Basically each JDM mirror should have a pair of connectors. One with 3 wires and one with 2 correct? The one with 3 wires should fit into the connector that your old pwr mirrors connected to. The connector with 2 wires should be the one that retracts the mirrors. You'll have to run 2 extra wires from each mirror to the switch to hook up the folding action. If you don't have the connectors on the mirrors and they are all just together, I'll PM you the colors for the 3-wire connector. But I can't remember off hand what the other 2 wires were.

At the switch, you will probably have to splice in all the wires because they use different connectors. Most of the wires should match but there are a few power source wires and such. I may have a diagram that I made. Like I said, I studied the wires pretty good so that wiring them up would be simplified.

Now if you don't have pwr mirrors originally everything will have to be run on it's own. Basically along the same route as the door speakers.

Garrett