Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - clutch and flywheel installed...but won't go into gear

nrcooled · 12-29-2002, 08:06 PM

After 7hrs...that's right 7hrs, the clutch and flywheel went in oddly enough w/o a hitch. Except for the fact that my clutch pedal went straight to the floor and it wouldn't go into gear. I am thinking that I need to bleed the slave cylinder (which I didn't do...ran out of time at the hobby shop) but if anyone has suggestions they would be greatly welcome.

FYI I installed a SPEC stage II and Fidanza. The clutch I removed was sprung 3 puck ::I was wondering why it hooked up so well::

Everything was torqued to spec and the only thing I can think of is bleeding the slave cyl.

Thanks for reading and hope you have a good suggestion for me to use Monday.

12-29-2002, 08:06 PM	#1
nrcooled Nissanaholic! Join Date: Mar 2002 Location: Turn 8 'bout to get rolled by a SC'd ITR Age: 46 Posts: 1,849 Trader Rating: (0)	clutch and flywheel installed...but won't go into gear After 7hrs...that's right 7hrs, the clutch and flywheel went in oddly enough w/o a hitch. Except for the fact that my clutch pedal went straight to the floor and it wouldn't go into gear. I am thinking that I need to bleed the slave cylinder (which I didn't do...ran out of time at the hobby shop) but if anyone has suggestions they would be greatly welcome. FYI I installed a SPEC stage II and Fidanza. The clutch I removed was sprung 3 puck ::I was wondering why it hooked up so well:: Everything was torqued to spec and the only thing I can think of is bleeding the slave cyl. Thanks for reading and hope you have a good suggestion for me to use Monday. __________________ '91 hatch w/ SR Sold; '03 Evo Sold 401 HP; '03 MS Protege sold; '00 Evo 6.5 TME Sold 300HP