02-12-2008, 06:26 PM
|
#28
|
|
Zilvia Member
Join Date: May 2007
Location: victoria tx
Age: 36
Posts: 256
|
Quote:
Originally Posted by MadMaverick
When you took the trans down, did you put in a new clutch too? Check to see if the clutch fork pivot ball is broken. Make sure your clutch fork is properly installed (with the little spring clip). Make sure you properly bleed your clutch system afterwards. You should be able to watch the slave cylinder move the clutch fork from above.
|
ding ding ding! winner! |
|
|