Quote:
Originally Posted by Sileighty_85
Brian Crower Stainless Steel polished Valves, There Priced pretty good in my opinion
|
I don't see the point?
If you were running meth injection or high pressures/nitrous it might be insurance.
Unless they are larger valves, then they have a natural overal HP advantage.
It's not huge though.
S3 Cams Good Cam for linear power band just be very careful installing the blanks into each side via FSM torque specs and tightening sequence
Adjustable Sprockets (I don't see the point unless you are going to tune them on the dyno, and if you do it will get expensive because you have to manually remove the valve cover adjust thend o a pull then re-seal the valve cover then adjust and do a pull and so on and so on).
When you take your head to the machine shop you could also or should imo have the valve guides replaced with OEM (which should be fine) ask the machine shop to head up the head before inserting them. Pressing them in cold can score them up and disfigure them before you ever even get to fire the motor up.