Quote:
Originally Posted by Fries
Nismo needle pilot bearing
www.thenismoshop.com
Installed waaaaay easier.
Lined it up, used an auto flexplate bolt on the top of the bearing and then a 19mm socket on that "gently" tapped it with my huge ass hammer until it got flush with the crank then switched to a 14mm socket put the side that you usually connect to the ratchet and again lightly hit it until it stopped going in.
Installed clutch.
Pulled alignment tool out.
Done.
Thank you guys for the assistance! |
Cool glad you got it. I usually don't install the pilot bearing with a hammer, just put it on the end of the alignment tool and slide it in. I've never had to beat one in, just grease it and it should just sit in there. I've certainly never had problems pulling the alignment tool out lol.