Quote:
Originally Posted by jorgezee1
if your running an s14sr zenki harness pin number 9 on the ecu needs to see the signal from the triple presure switch.
Check the following
Pin #9 on the ecu
Pin #25 on the white plug
essentailly these correspond to each other. it should be a green/yellow wire.
Note: as stated above check the fsm manual and trace the wire.
|
Dont happen to know what voltage I should be seeing do you? Fuck I swear, when I tear this car down in less than 2 years, Im gonna go get a brand spanking new wiring harness...