[codyace]

Originally Posted by mjhockey155

I just installed my taurus fan. I am having trouble locating a spot to install my temp sensor probe. I was thinking about making a T for the upper radiator hose which would accept the 5/8inch probe. Below is a link for the fan controller I am using. Where do you guys think I should try to install the probe? Also, what temp sensor is on the right side of the ecu temp sensor.

Derale 16739 - Derale Single Stage Fan Controllers with Radiator Probes - Overview - SummitRacing.com

If you want to use the actual coolant for a source, check out:
Water Feed More Info


I use the Dual Fan Derale Controller with the radiator probe. Works amazing, and has had no issues. I have my drivers side fan on full time (Altima fans) and use the controller to turn the 2nd side on high at 180 degrees, or when AC is turned on. Works like a charm, and it's nice and small (and cheap)

I used my fuel pump relay source, as my relay soruce. This way it just doens't come on when i have the key switched to the on position without it running. I always let the car prime before start, so it's not on at all when i crank it over.