Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

mkslide · 12-11-2009, 05:37 PM

so i did a burnout and now the clutch will not dis engage. This happened one time before but i drove it for a little and it went away. This time it wont

i have adjusted the master cylinder and its pushing the slave. All the pressure is still there but when i push the clutch nothing happens

it wont go in gear. or i can start the car in 1st gear and start driving but when i push the clutch in nothing happens it stays in gear

is this a bad pressure plate or something else. Is it possible the clutch can stick to the flywheel. i mean all the pressure is there
its and ACT 6 puck sprung clutch.

12-11-2009, 05:37 PM	#1
mkslide Leaky Injector Join Date: Jun 2008 Location: las vegas Age: 34 Posts: 61 Trader Rating: (1)	Clutch wont disengage so i did a burnout and now the clutch will not dis engage. This happened one time before but i drove it for a little and it went away. This time it wont i have adjusted the master cylinder and its pushing the slave. All the pressure is still there but when i push the clutch nothing happens it wont go in gear. or i can start the car in 1st gear and start driving but when i push the clutch in nothing happens it stays in gear is this a bad pressure plate or something else. Is it possible the clutch can stick to the flywheel. i mean all the pressure is there its and ACT 6 puck sprung clutch.