|
I made a protector for my wiring harness. I used a coffee can from a vending machine (I live in Japan, we have them everywhere), but any sort of aluminum or thin soft metal will work, and I cut the ends off and made a slit down the center. I then removed all original (IE Bulky) wiring harness protection and wrapped all my wires with e-tape. Then I wrapped the wiring harness with the cut up coffee can and used 2 small hose clamps to tighten the can to the harness and hold it in place. Just be sure to cut the excess of the hose clamps off and make sure that the smoothest ends are facing the tire (duh). This was a very easy solution and I have not had any wiring problems from rubbing since then.
|