Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - VERY LONG Rebuild Parts List. Please tell me what I can add/take off it.

DamnedButDetermined · 10-28-2003, 10:52 AM

I was looking at a Toyota Factory service manual and located all of the wear items and parts that might begin to leak over time and made a large list of everything. I know some of the parts are going to have different names, but that was the only manual i have right now because i work there. It was from a DOHC engine though. I am pretty sure that I have a lot of unneccessary parts on this list and that is what the experts are for. So without further adue (sp?)

Engine Block

low compression pistons
Piston rings/expanders
piston Pins
Piston snap rings
connecting rods
connecting rod bushings
connecting rod bearings
connecting rod bolts/nuts
crankshaft bearings
crankshaft thrust washers
crankshaft front oil seal
crankshaft rear oil seal
rear oil seal retainer gasket
rear oil seal retainer--- Do you think this will be warped at all?
oil pump---Would it make any difference to upgrade this from stock?
oil pump gasket
water pump---Would it make any difference to upgrade this from stock?
water pump o-ring
water pump gaskets
oil pan gasket
drain plug gaskets
oil filter assembly---gasket, o-ring, oil cooler, plate washer, releif valve, oil filter

Cylinder Head

valve cover gasket
spark plug grommets
PCV valve
PVC valve grommet
intake/exhaust valves
valve guide bushings
spring seats
oils seals
valve springs
spring retainers
keepers
valve lifters
adjusting shims
camshaft bearing caps
camshaft oil seals
cylinder head bolts
cylinder head gasket
timming chain kit

k that was a long list and i know there are things on there that are not needed so please share your experiences.

This rebuild will be for either a 91 105K miles or 97 130K miles KA.

Can you please share where you bought the parts for your rebuild and how much you spent? I have only found two places online and theye seem a little expensive. www.ka24de.com and http://www.rpmrons.com/index.html

What company do you trust the most in rebuild parts?

What other services should i have done to the engine block and cylinder head while I have them disassembled?

thank you for your time,
DbD

10-28-2003, 10:52 AM	#1
DamnedButDetermined Zilvia Addict Join Date: Oct 2002 Location: Jax, Fl Age: 43 Posts: 637 Trader Rating: (1)	VERY LONG Rebuild Parts List. Please tell me what I can add/take off it. I was looking at a Toyota Factory service manual and located all of the wear items and parts that might begin to leak over time and made a large list of everything. I know some of the parts are going to have different names, but that was the only manual i have right now because i work there. It was from a DOHC engine though. I am pretty sure that I have a lot of unneccessary parts on this list and that is what the experts are for. So without further adue (sp?) Engine Block low compression pistons Piston rings/expanders piston Pins Piston snap rings connecting rods connecting rod bushings connecting rod bearings connecting rod bolts/nuts crankshaft bearings crankshaft thrust washers crankshaft front oil seal crankshaft rear oil seal rear oil seal retainer gasket rear oil seal retainer--- Do you think this will be warped at all? oil pump---Would it make any difference to upgrade this from stock? oil pump gasket water pump---Would it make any difference to upgrade this from stock? water pump o-ring water pump gaskets oil pan gasket drain plug gaskets oil filter assembly---gasket, o-ring, oil cooler, plate washer, releif valve, oil filter Cylinder Head valve cover gasket spark plug grommets PCV valve PVC valve grommet intake/exhaust valves valve guide bushings spring seats oils seals valve springs spring retainers keepers valve lifters adjusting shims camshaft bearing caps camshaft oil seals cylinder head bolts cylinder head gasket timming chain kit k that was a long list and i know there are things on there that are not needed so please share your experiences. This rebuild will be for either a 91 105K miles or 97 130K miles KA. Can you please share where you bought the parts for your rebuild and how much you spent? I have only found two places online and theye seem a little expensive. www.ka24de.com and http://www.rpmrons.com/index.html What company do you trust the most in rebuild parts? What other services should i have done to the engine block and cylinder head while I have them disassembled? thank you for your time, DbD