[DRIFTO16]

so i replaced the clutch setup on my car a removed everything while doing so i noticed
the rings on my center support bearing where very lobsided and bent so
i assumed that might have caused the noise i would hear when releasing the gas at 3k rmp
so i was happy to replace the center support bearing with a new one
i threw everything back on
and the car started fine but when trying to reverse the car outta the shop
i heard rubbing but it had nothing to do with cluth it felt great i knew it would be the center support bearing
even when car is off
and in neatral and i push it feels realy hard to push
as if the driveshaft isnt moving easy enough
and at that same moment i hear that noise i lifted the car again and well idk the driveshaft doesnt seem to move easy with my hand like it should
any help would make my day =]
and nooooooo the e brake wasnt on lol