Quote:
Originally Posted by Tkwjh07
So I went to take a look at the intake, it look like the person before me replaced it because there is not a place for me to put the hose, should I weld one on or just buy another intake with it?
|
Your using an upgraded turbo , so I highly doubt your using the stock rubber MAF to turbo intake. You probably using custom metal piping, if this is the case have some one weld a 3/4 or 1" small pipe at an angle toward turbo . That way when pressure enters it wont blow upstream and disturb MAFS input readings.After fabricating this just run a hose from BOV to pipe.