Quote:
Originally Posted by slider2828
|
If you learned how to read the original before posting a stupid response, you would have seen...
Quote:
Originally Posted by zooopreme
So...I've been searching far & wide for the answer to this.
Excuse my really bad illustration but:
Like the drawing, I wired both colored wires (green & red) on to the new two wire harness and left the black (ground?) wrapped in electrical tape. Unexpectedly, the lights do not work for turn signals but work perfectly for what they were intended for: position lights. They work for hazard lights & do not light up for signals. As a result, the tailights & cluster light blink rapidly.
I followed this exact thread-- http://zilvia.net/f/archive-faqs/169...t-install.html & the results are stated above.
|
So uh...if you're not going to help...
