[Tempo]

Originally Posted by thefro526

Awesome post, I should be doing this shortly.

How hard was it to put the fender back on over the harness?

slipped right on without any problem

Originally Posted by xoxide

I applaud the effort, but that is a fucking hack job.

meh its hidden under the fender long as i got the piece out, first time cutting. one day ill come back to eventually when i become pro at pro cutting

Originally Posted by fliprayzin240sx

+1093480938 Atleast smooth the damn edges. What makes you think the sharp edges wont cut thru the duct tape and the harness sleeve from all the vibration? Besides, you only showed a very small piece of the tucking process.

• *Throw in any other steps you want to make it satisfactory to your project goal

^^^ see above, works out for my buddies who did it themselves no problems in the 5 years theyve had it like that. True, I rushed the thread before i went to sleep, so ill add more detail to the tuck when i get more pictures.

Originally Posted by silviaks2nr

don't use zip ties. use screw in harness clip/anchors with rubber gromets.

• *Throw in any other steps you want to make it satisfactory to your project goal

zipties work fine but if screws work for you then have at it.

Originally Posted by blueshark123

not for anything but this has been covered over 100 times and you did the worst job possible

how so? because my cuts were off by a quarter inch? or i didnt smooth out the edges? please elaborate.

Originally Posted by Hiighboost2

I was expecting something a bit cleaner..

• *Throw in any other steps you want to make it satisfactory to your project goal

Originally Posted by ManoNegra

This is not the thread I've been looking for.

???

Originally Posted by SuperBlackS14

Was expecting something a bit more comprehensive, good effort tho.

more info to come

Originally Posted by dtfdanyo

nice job taking the time to do a write up, but that shit ratchet.

rushed thread before i slept , ill add more info when i can.