LOCATION: Collierville, TN
BEST CONTACT METHOD: PM
PAYMENT OPTIONS: Cash or Paypal
SHIPPING: At Buyers expense
ITEM: SPL S13/S14 outer tie rods
DESCRIPTION: only used for about 8K miles, switched to a different inner/outer tie rod setup for knuckles
PRICE: $165($175 shipped)
SOLD
ITEM: Inner Tie Rods
DESCRIPTION: Z33 Tein inner tie rods, only used for about 8k miles, needed longer tie rods because I got different knuckles. In very good condition.
PRICE:$60 ($70 shipped)
SOLD
ITEM: OEM S15 480cc injectors, with S15 fuel rail and FPR
DESCRIPTION: Good condition, working injectors pulled from a S15 SR20
PRICE: $100 ($115 shipped)
ITEM: OEM S14 SR20 370cc injectors
DESCRIPTION:working injectors pulled from a S14 SR20, some of the tips on the end are cracked/ missing the little tabs. Connectors pictured but not included.
PRICE: $80 ($90 shipped)
ITEM: 2.5" I.D. springs
2x Eibach 7" long 275lb (0700.250.0275)
2x GC/Eibach 5" long, ~430 lbs (GC125.64.75)
2x GC/Eibach 8" long, ~380lbs (GC200.64.67)
PRICE: $70 shipped per pair
ITEM: S13 Rear Upper control arms
DESCRIPTION: Used, old RUCA. Will need new rod ends.
PRICE: $10 ($20 shipped)
ITEM: Lug nuts
DESCRIPTION: Muteki Lug nuts, Neo chrome, being used for a while and the coating is chipping off but threads are perfect. Only have 17 so it would only work for 4 lug cars
PRICE:$20 ($30 shipped)
SOLD
ITEM: FLCA
DESCRIPTION: Godspeed FLCA. I started modifying these for roll center correction based on this write up:
http://www.nissanroadracing.com/showthread.php?t=1407
I have already reamed out the bearing hole and pressed in the ABI-12T bearings. Will also include the 3/4" bolt, lock nuts, and the godspeed rod ends. I don't have the misalignment spacers for the rod ends. ( the bearings and hardware cost ~$50.
PRICE:$100 ($120 shipped)
ITEM: Stock S13 front spindles
Price: $60 ($80 shipped)