Quote:
Originally Posted by travon47
Z33 is not a r230, it is still a r200. The rear bushing did not fit on my 05 g35 auto trans. the knurl on the stud is too large for the bushing how it was machined and I had to modify it. Also like Jorgs said, they are a press fit and I have no idea how you can line these up properly while pressing them in, not to mention I hogged the shit out of my diff flanges on the front just to make it start to slip in for the first part( how these are machined).
Also I have a little bit of camber, but my axles are 100% compressed with the diff just sitting in the subframe without the mounts( hardly off from where it would sit) So it looks like extended rlca are a must, atleast for me.  |
My bad.
Could you measure the distance between the snout mounting holes then make a U shaped bracket with similar bolts. Slip bushings on bracket then hold up to differential and twist them until everything lines and press in
Sent from my XT1575 using Tapatalk