|
1.. make sure you have the correct caliper on the correct side of the car(bleeders pointed up)
2...all lines are tight and no leaks
3... start bleeding procedure.. left rear, right rear, left front, right front
4... best way is to get a vacuum bleeder.. but 2 person system works. Press brake pedal down, open bleeder, air/brake fluid will come ouy, close bleeder, release(pull up) brake pedal. Keep repeating till no air comes out of the bleeder. Then move on to next caliper and repeat.
If your getting no fluid out of the bleeders few things..
Inproper installation(wrong side caliper)
Check the bleeders, for corrision and debris stuck in them and check the port on the caliper. Make sure there clean.
Leaking hose, fitting, calipers
Seals bad in master cylinder (no pressure) happens to new pars
Good luck
|