alright i finally got all my parts together.. here's what i have
i have:
Manual Transmission
Shifter
Release Bearing
M/T Mounting plate
Clutch pedal
Crossmember
Driveshaft (other half not in pic)
Brake pedal (From M/T car)
Clutch master cylinder
Clutch slave cylinder
Hydraulic Lines: i only have the rubber one attached to the clutch slave
Shift boot and plate
96 Manual ECU that i'm not going to use because I have a '97. I'm going to go with the Auto ECU until i get a 97/98 Manual ECU
already installed on my car-
Pressure plate
Clutch
Flywheel from a m/t
stuff i have for the missing parts on tranny-
clutch fork
clutch alignment tool
dust cover
release bearing
ordered a release sleeve and a retainer spring
some sensors in the other pictures but i dont know which they are.
here is what my tranny looks like..
is there anything else i'm missing besides a speed sensor and clutch hardline?
i've searched through a lot of manual swap guides but none really answer my question. i spent a lot of time on this post, so if you guys could help me, i'd really
appreciate it.
thanks