[krazykoncepts]

Hey guys,

I am currently getting a sr20det engine and tranny rebuilt. Here is the list of internals that are currently going into the engine. Is there anything i am overlooking? Also how much hp at the crank do you think this setup should be good for?

Hone/machine bores - 80
Zero deck the block - 100
Balance rotating ass. - 150
Valve lapping - 50
Port Mach intake/exhaust - 400
Nismo rings - 125
Nismo rod bearings - 150
Nismo main bearings - 150
Nismo thrust bearing - 50
Nismo rear/front main seal - 30
Nissan valve stem seals - 80
New SR water pump - 170
New SR oil pump - 130
ARP Head stud set - 130
ARP rod stud set - 130
Cometic head gasket - 100
Machined flywheel - 150
Nismo/Unisia Street clutch - 325
DD pressure plate - 200
HD release bearing - 40
New SR clutch fork - 25
New 3/4 clutch cylinder - 75
New Synchros - 190
New bearings - 200
New seals - 50

Cam angle sensor - 150

prices are in cnd dollars btw
thanks