Ok I have the pictures but let me say this first. I used the word I too loosely when I said I did it. My Brother in law actually did it and after talking to him I found out what I was doing wrong. Here are the parts you will need to do this and make it fit.
4 1" rubber I guess you can say washers they have to have a hole for the screw.
4 2 1/2" bolts to screw into side of light the ones that come with it are too short.
1 extra set of Blinkers ( you have to cut the top screw mount off)
You will need a new center grille The skyline center grille.
You will need to drill the top hole for the side light mount. It will not interfere with the original set up.
I had all the holes drilled already so you will have to make holes for the rear mount brackets ( the long plastic with the bolt sticking out. The light need to be aligned again to keep from blinding other drivers. Considering it is a LHD light and the beam will be in on coming traffic anyway you will need to pull up to a wall and turn the lights on and make sure it is a knee level.
There is a little Fabrication you ahve to do to make it fit gaplessly but there will be a gap. Honestly I don't remember their being one but it will be between the light and the S14 Blinkers. Here you will use black foam rubber to fill. It has been a long time since I did this and I did not remember there being a 1" gap between the Light and the Blinker. Sorry for the misleading idea of this just being a bolt on thing. I was done to my car and it did not look bad When I replace all the stuff that I threw away from making it original again I will put it all back together. What I did today took me all of about 20 min to take off the S14 and put on the 32. If you have any more q's just PM me.
Here are the pics
My Silvia and Misc cars of Jaoan click this title