|
the problem isn't setting the closed throttle tps voltage, it's that when i open the throttle completely it barely makes it past 1 volt, and i'm asuming (but not sure) that the tps is powered by a 5 volt source, or at least something higher than the .6 it is getting from the ecu at the moment.
i should mention that i measured the connector aswell as the ecu pin, both came out the same so it isn't a short. and when i checked the groundside of the tps connector (multimeter on connector pin and bat -ve) i only got 1 ohm or so of resistance so the ground is good aswell.
|