|
as far as the valve cover goes goto the auto parts store and get high temp engine enamel/paint and get high temp clear enamel.Take off your valve cover when it is cool and clean it off very well try sanding it down some to make it smoothand to get any unwanted grime off that may have stained it"oil,greeseetc...".Then put about 5-8 coats of paint on and let dry every 2-3 coats for about an hour.Then when you get the paint on let it dry for a few hours so it set on well.Then put the clear coat on put almost if not double the amount of coat that you did paint to get that glossey look then let dry for about 24 hours so it stays and looks good.Be careful when putting it on cus you can nic the paint up.The if you want a cool look and you have access to a hand help belt sander take that and run it accross where it say nissan twin cam on the top.I will show you a pic of my valve cover.
If this is a twin cam then you have spark plug gasket as well right before the plugs check that or may be your socket is to big to fit in the hole for the plugs i don;t know exactly but you moter to your wipers could be gone in the front i belive they run on seperate moters for the front and the rear
|