|
</span><table border="0" align="center" width="95%" cellpadding="3" cellspacing="1"><tr><td>Quote (rampid360 @ June 16 2002,7:51)</td></tr><tr><td id="QUOTE">3. Sleepy Eyes (s13)
1. Make sure headlamps are off and in the "closed" position.
2. Get down on your back and look up through the large opening in the lower front bumper.
3. Look directly under the left and right headlamps and find their electronic plugs.
4. Now while you are down there, you can reach through the large opening and unplug the electronic plugs left and right. You must unplug these in order to adjust the headlamp motors manually.
5. Now get off the ground and pop your hood. You should see a headlamp motor next to each of the headlamps. Looks like a single prong.
6. Pull the cap off each headlamp motor. Now you may manually adjust the headlamp angle at any variable by turning the knob. Make sure that both headlamp motors are evenly adjusted.
7. Now turn your headlamps in the "on" position. Notice the motors dont move and the headlamps simply light up. Viola, instant "sleepy look."
**Now in order to get the headlamps in its original position you have to manually adjust the headlamps in the "closed" position via the motor. Then plug the wiring back together.</td></tr></table><span id='postcolor'>
no need for that, i reacall we discussed this on the board b4, get into the driver side kick panel fues, pull the 10A one that says headlight motor or somthing. voila, no need to disconnect anything. and u adjust the same way. only thing is, if u flash ur high beam, the headlight pops up, and u have to adjust it down again.
__________________
|