Quote:
|
Originally Posted by fliprayzin240sx
Like I said before, if your gonna drop the tranny, you might as well go ahead and buy a Z32 TOB. Its a tad bit thicker than the SR/KA TOB and should alleviate that issue. If you put back the tranny and does this shiet again, then youll end up with 1 gheto solution, find a longer replacement for the slave cylinder pin or else, your dropping the tranny again.
|
The t/o bearing wasnt the issue till the release fork slipped off the holder and was pushing directly on it now its toast and thats why it wont stay on the holder. When I put the release fork back on the holder like its supposed to be there is no slack between the end of the fork and the slave if it was any thicker it wouldnt be right I dont think, so I am dropping the trans to fix the clip and replace the now destroyed t/o bearing.