Quote:
|
Originally Posted by junks13
all right i just bought a very straight sr5 corolla and was wanting to drop in a ka24e iv got the motor trans and wiring i know ican get the motor in the car but im concerned about the wiring what would i need to do to make it run please help thanks  |
youre in luck. i posted this build on another forum but here's what im doing to my AE86 (its an ongoing project so its still not completed yet...wiring needs to be done still):
So I blew my motor and decided to swap in something a little different:
pulling out the POS 4AGE (excuse the GAY stock pizzacutter wheels for the time being)
then after pulling out the entire harness, ECU, and motor, i found this:
dammit! i probably didn't blow my motor after all! well i was too far along already...so I decided to continue anyways...
motor out
a last look at the stock crossmember...
the beast sleeps for her big day tomorrow...
Nissan KA24DE= plenty of torque!
cleaned out the motor...installed the custom crossmember
close up of the welds on the new custom mounts
dropping it in...
so close...but no lighting so we'll try again later
got the motor fully mounted...had to bang out the tranny tunnel and firewall to get it to fit as snug as possible without cutting anything. sorry i havent been working on this much been pretty busy at work...
custom tranny mount out of box steel
passenger side tranny/firewall clearance
driver side tranny/steering rack/firewall clearance
head/firewall clearance
yum
