Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

Kn1ves · 01-30-2007, 02:16 AM

Not everyone thinks these wheels look good, but I beg to differ.
There is not a lot of information on them online regarding to where they are built, how they are built and I hope to shed some light to that. They are made in China, low pressure cast aluminum and the 17x9 +20 are about 23lbs each.
They're only a couple of hundred bucks cheaper than the FN01RCs and are heavier by about 4lbs.
They also clear coilovers and Z brakes according to this guy

Wheels in question in Bronze

and Silver

Another pic here

Hmm... I was going to ask if I should buy them or not, but my mind is set (since im getting a good deal on them). Unless you guys scare me off with horror stories of them being cheap quality etc.

01-30-2007, 02:16 AM	#1
Kn1ves Zilvia FREAK! Join Date: Jul 2005 Location: ɐɔ 'sǝlǝƃuɐ sol Posts: 1,281 Trader Rating: (0)	Falken Hanabi 17x9 +20 Not everyone thinks these wheels look good, but I beg to differ. There is not a lot of information on them online regarding to where they are built, how they are built and I hope to shed some light to that. They are made in China, low pressure cast aluminum and the 17x9 +20 are about 23lbs each. They're only a couple of hundred bucks cheaper than the FN01RCs and are heavier by about 4lbs. They also clear coilovers and Z brakes according to this guy Wheels in question in Bronze and Silver Another pic here Hmm... I was going to ask if I should buy them or not, but my mind is set (since im getting a good deal on them). Unless you guys scare me off with horror stories of them being cheap quality etc. __________________ there's something here