|
cotbu when i hooked up the camander it was reading .22v but i adjusted it to .45 give or take closed. 4.45v give or take fully open. that was one of our first probs on first start up but no longer. the vid is after adj of tps. nassin31spr i would like to get a ecm pin out so i can chk for open/ high risis on the signal wire of o2. it was sheilded but had to extend it. ne one have probs with sig wire on o2 not being sheilded bit of RFI maybe. the camander let you know if one of you sen. are not hooked up (will be highlighted if not conected) its shown that its there but its jus not doing ne thing. nassin31spr were you got the coolant lines on bottom of t/b goin to??
|