Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

jafero · 04-15-2007, 04:42 PM

Chassis: 89 S13
Engine: KA24DE

I'm wrapping up putting in a new engine. Car is sitting on top of jack stands. While bleeding the coolant system I noticed that speedometer was at 10 mph. So I looked at the rear wheel and it was spinning. All these are happening when the gear is in neutral and if I gently push the shifter, speedo needle goes up. Also I can engage any gears without pressing clutch.

New clutch, new throwout bearing.

What could be wrong here?
Is there a chance that clutch remains engaged in neutral gear?

04-15-2007, 04:42 PM	#1
jafero Leaky Injector Join Date: Jun 2006 Location: NJ Posts: 129 Trader Rating: (0)	Clutch not disengaging Chassis: 89 S13 Engine: KA24DE I'm wrapping up putting in a new engine. Car is sitting on top of jack stands. While bleeding the coolant system I noticed that speedometer was at 10 mph. So I looked at the rear wheel and it was spinning. All these are happening when the gear is in neutral and if I gently push the shifter, speedo needle goes up. Also I can engage any gears without pressing clutch. New clutch, new throwout bearing. What could be wrong here? Is there a chance that clutch remains engaged in neutral gear?