|
RedTopTech, i assume you meant - 0.0011" on the rods, and not 0.00011".
These are basicly , the Recomanded clerances, in the Manual.
I used a bit difrent Runing in procedure, but allso got about - 5-6% losses on leak down test.
Anyway, not sure what power are you runing, but the question here is what to set the clerances for about 450-500 HP !
At 300HP, i trashed the car for about a year, but what went at the end, was a rod bearing. The OEM tight clerances, might have had something to do with it - when the car ran of the limiter, during a drift sesion.
|