Thread: Bypassing CAS?
View Single Post
Old 12-17-2007, 06:04 PM   #8
RedtopTech
Zilvia Member
 
RedtopTech's Avatar
 
Join Date: Dec 2005
Location: Virginia Beach, VA
Age: 40
Posts: 293
Trader Rating: (0)
RedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud ofRedtopTech has much to be proud of
You could simply wire the bulb into the ABS or oil pressure bulb circuit with some wire and 2 scotch locks than remove it afterwards however the code will still be in the computer. If all they perform is a bulb check than you should be fine.
RedtopTech is offline   Reply With Quote