|
Thanks all for the compliments, comments and suggestions. The trunk build up was a total abortion due to the low points caused by the Type R wing and the GT wing that were previously mount on the trunk. I have decided to do away with the stock trunk and an FRP trunk from MeisterR is enroute. Once it gets here I will sand it, cut the holes for the aerocatch pins and the car will go into paint. I wanted to make sure all was flush, but it just didn't work out well, I will most likely make minor adjustment and close the difference in height to about 1mm which is barely noticeable.
Once the car is out of Paint, it will sit a while and harden while I work on things like the dash board, knuckles, bearing replacements and things like that. I will update pics tonight as I start on my dash project. Once the paint is ready, I will wet sand and then start to assemble this pig.
Brian
|