|
Alright everything electrical works on my car BUT the starter.
I have the positive cable that runs from the distribution block down past the fuse box and to the nut on the starter. This cable has a few smaller wires coming off it as well. This large cable has 12v when battery is hooked up.
Now for the starter it has the one bolt which the above wire is attached and then a male spade end. I thought this was the ground but I figure the starter grounds to the tranny when bolted up. So I have two female spade plugs in the general area. One is grey and one is black with a brown rubber cover. The grey does not output any voltage when the key is turned. The other with the rubber outputs 12v when the key is turned. I have tried both of these female spade plugs and neither get the starter to do anything.
Any suggestions?
|