|
alright plain and simple, yes its a bolt up. Use the CA motor mounts, if not the motor will sit higher. other than that, the driveshaft will work. the gearboxes are the same as SR/KA. I am using a s14 sr20 gearbox mated to the ca bellhousing on the tranny. wiring is straight forward and the only difference from the sr wiring job to the ca is that you need to wire the knock sensor directly to pin 23 iirc on the ecu.
ive been rockin the ca for awhile. you can pick up a motorset for about a grand. and honestly i wish i went with the rb20. still want it. but anyway good luck.
|