Thread: Why's the FSM say to remove the injector rail when doing an injector?
View Single Post
Old 05-14-2008, 06:03 PM   #14
alkemyst
Zilvia Addict
 
alkemyst's Avatar
 
Join Date: Oct 2003
Location: Florida
Age: 54
Posts: 868
Trader Rating: (0)
alkemyst is just really nicealkemyst is just really nicealkemyst is just really nicealkemyst is just really nicealkemyst is just really nicealkemyst is just really nicealkemyst is just really nicealkemyst is just really nice
Send a message via AIM to alkemyst
Quote:
Originally Posted by nastjuid View Post
I just did my injectors. Pulling out the rail, I was able to avoid damage to the injectors. Philips head screwdriver wrapped in a terry towel to push on the spray side of the injector to get it to come out of the bowl along with another screwdriver and towel to pull up on the injector from the top. Eased right out. Sure, you don't have to pull the rail out, and for most people that's preferable, but I was also replacing the injector-to-manifold donut. Removing the rail would also give you the opportunity to check those, or break them in the process of removing the rail. :/
Well I am not terribly worried about screwing up the old injectors since I have new ones...I definitely don't want to risk needing a part I don't have though.

My injectors have two new O-rings on each with lube.

I don't see those 'donuts' in my FSM....are they on all KA24DEs?
__________________
Now my Kensai, I curse you to be a Ronin and with the my remaining spirit I, beseech Chimata-No-Kami, to have you wander through time and distance lands, seeking a new master.
alkemyst is offline   Reply With Quote