|
I do not have the dimensions for the cage. I found a local roll cage shop and took them cardboard templates and they bent the main hoop and a pillar bars from there. They left them long so I could cut them to fit. If by gussets you are refering to the plates that attach the a and b pillars to the cage I made those myself. I have the dimple dies and a press. The firewall was the same as the cage I made a cardboard template that got me close and then it was a lot of in and out of the car to take a little off hear and there. I made the firewall one piece and then had to make two small patch pieces at the top sides where the stock sheet metal does not go all the way around. Hope this helps,
JKP
|