Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

rps13sr20det · 05-22-2008, 12:05 PM

Howdy,

I just had a question and was wondering if anyone else has had the same problem.

I just finished replacing my S13 4 lug using Ichiba 5 lug. I purchased Brembo blanks instead of doing a re-drill on my old rotors.

I have factory calipers, SS lines and purchased new brake pads, so the new rotors should have just slid on.

BUT..... It seems that the studs will go on individually, but when I line up the rotor to go on the studs. the brake is a just barely off from sliding on. The hub bore is the same as factory.

MY QUESTION IS: if i bore out the rotor slightly, will this be dangerous?

Thanks for the help.

Jonny

05-22-2008, 12:05 PM	#1
rps13sr20det Leaky Injector Join Date: Nov 2005 Location: calgary, AB Posts: 128 Trader Rating: (0)	Brembo Brake Problem: Howdy, I just had a question and was wondering if anyone else has had the same problem. I just finished replacing my S13 4 lug using Ichiba 5 lug. I purchased Brembo blanks instead of doing a re-drill on my old rotors. I have factory calipers, SS lines and purchased new brake pads, so the new rotors should have just slid on. BUT..... It seems that the studs will go on individually, but when I line up the rotor to go on the studs. the brake is a just barely off from sliding on. The hub bore is the same as factory. MY QUESTION IS: if i bore out the rotor slightly, will this be dangerous? Thanks for the help. Jonny __________________