Thread: Clutch Problem RB20 Tranny
View Single Post
Old 05-23-2008, 09:28 PM   #6
Drift N Dragg
Username Monster!
 
Drift N Dragg's Avatar
 
Join Date: Dec 2007
Location: Earth?
Posts: 2,700
Trader Rating: (14)
Drift N Dragg has much to be proud ofDrift N Dragg has much to be proud ofDrift N Dragg has much to be proud ofDrift N Dragg has much to be proud ofDrift N Dragg has much to be proud ofDrift N Dragg has much to be proud ofDrift N Dragg has much to be proud ofDrift N Dragg has much to be proud ofDrift N Dragg has much to be proud ofDrift N Dragg has much to be proud ofDrift N Dragg has much to be proud of
I checked the Throw out bearing it was not all the way seated. So I seated it.. Now I got the Slave Cylinder on. Now I bleed the Master Cylinder and the Slave Cylinder. But It isnt hold all the pressure built up. like if i left it go for like 30 seconds it will still move the slave Cylinder about a 1/4 inch.. but if i pump it twice it will go back 1/2 .. Now I rebuilt the Slave Cylinder.. could the Master Cylinder be Bad? If so, is there a way to test that?
__________________
Quote:
Originally Posted by !Zar! View Post
More so disgusted. Much like how a dog owner reacts when they notice a dog about to eat some shit off the ground because the dog thinks its a good idea.


2015 Subaru STI
1997 Mitsubishi Eclipse GSX
A Ton of Projects
Drift N Dragg is offline   Reply With Quote