Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

1slowS13 · 06-02-2008, 05:30 PM

my car would throw a code 34 every now and then, so i finally got around to replacing it.

when i was cleaning up the wiring, the harness that connects to the sensor itself only had 1 pin, and it was for the signal wire. i opened up the wiring and saw that the ground pin from the harness just grounded to the shield of the harness itself and unto the engine.

yes, i searched.

is this normal?

06-02-2008, 05:30 PM	#1
1slowS13 Zilvia Junkie Join Date: Jan 2008 Location: Las Vegas, NV Age: 35 Posts: 466 Trader Rating: (6)	knock sensor ground? my car would throw a code 34 every now and then, so i finally got around to replacing it. when i was cleaning up the wiring, the harness that connects to the sensor itself only had 1 pin, and it was for the signal wire. i opened up the wiring and saw that the ground pin from the harness just grounded to the shield of the harness itself and unto the engine. yes, i searched. is this normal?