Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

240sxrb25 · 06-10-2008, 10:41 PM

i am replacing a blown head gasket on an engine that wan hardly run after the blow of the gasket.

i used a feeler gauge and straight edge on the head and could only get the .002 gauge through one spot.

what is the max warp tolerance on a ka24sohc?

thanks a lot

06-10-2008, 10:41 PM	#1
240sxrb25 Zilvia Junkie Join Date: Aug 2006 Location: omaha, ne Age: 35 Posts: 451 Trader Rating: (2)	head warp tolerance. ka24e i am replacing a blown head gasket on an engine that wan hardly run after the blow of the gasket. i used a feeler gauge and straight edge on the head and could only get the .002 gauge through one spot. what is the max warp tolerance on a ka24sohc? thanks a lot