Thread: The fabrication thread.
View Single Post
Old 06-25-2008, 09:30 AM   #722
TougeLabs
Premium Member
 
TougeLabs's Avatar
 
Join Date: Jan 2007
Location: New York
Age: 39
Posts: 1,570
Trader Rating: (7)
TougeLabs is a splendid one to beholdTougeLabs is a splendid one to beholdTougeLabs is a splendid one to beholdTougeLabs is a splendid one to beholdTougeLabs is a splendid one to beholdTougeLabs is a splendid one to beholdTougeLabs is a splendid one to beholdTougeLabs is a splendid one to beholdTougeLabs is a splendid one to beholdTougeLabs is a splendid one to beholdTougeLabs is a splendid one to behold
Send a message via AIM to TougeLabs
I think i figiured out a good way to make this work...Going to drop my motor down 3/4" so Im going to run an elbow that brings the throttle body in and facing forward. For the Master issue I need a Z32 master.
TougeLabs is offline   Reply With Quote