Ok. so i just got off the phone with APEXI and the harness clip for the solenoid is supposed to plug into the engine harness for the stock wastegate solenoid. Sometimes that part of the harness is not transfered when people swap the engines so you need to take the new solenoid wires and solder them go the ecu.
As follows:
pink wire from new solenoid harness solders to pin 111 on ecu which is color orange/black.
brown/black wire from new harness solders to ecu ground wire.
__________________
Pre Tune Checkup! Compression,LeakDown,Vacuum Test $80. Cams Install: $180
Last edited by SoguRacing; 11-07-2008 at 01:22 PM..
|