|
did u buy the bars yet? if not then there are some good deals online. or else if u r lazy to check then i can get them for $65 then ship them to u, shipping unknown.....these are the tools you need... a socket wrench (hehe dont even need deep sockets for the 240sx) and a torque wrench... take off the 6 nuts (3 on each side) then adjust the bar to the right size by turning it, just try to make it even on both sides. when you are close put one end on and turn the other end to fit... then tighten the bar by turning it, then tighten the nuts for the adjustmen... then torque down the nuts... i will have the torque specs tommorrow, i just ahve to look in my trusty chilton manual. then tighten the adjustment nuts one more time.... if u can then use a high torque wrench to tighten it but not too tight (i used an air gun, becareful not to over tighten) then u r done....
simple? if u ahve 1/2 a brain u can figure it out... if u have less than 1/2 a brain then i can help u some more... hehe =)
|