Thread: clutch throw out bearing problem
View Single Post
Old 12-14-2008, 11:34 PM   #3
civilized_drifter
Zilvia Junkie
 
civilized_drifter's Avatar
 
Join Date: Oct 2006
Location: spring hill, TN
Age: 36
Posts: 584
Trader Rating: (0)
civilized_drifter is a glorious beacon of lightcivilized_drifter is a glorious beacon of lightcivilized_drifter is a glorious beacon of lightcivilized_drifter is a glorious beacon of lightcivilized_drifter is a glorious beacon of lightcivilized_drifter is a glorious beacon of lightcivilized_drifter is a glorious beacon of lightcivilized_drifter is a glorious beacon of lightcivilized_drifter is a glorious beacon of lightcivilized_drifter is a glorious beacon of lightcivilized_drifter is a glorious beacon of light
Send a message via AIM to civilized_drifter
i had bought 2 throw out bearings cause there were 2 different part numbers. so it might be just that its reversed? but would the stock one be strong enough for the upgraded pressure plate?
__________________
civilized_drifter is offline   Reply With Quote