Quote:
Originally Posted by cincyse_ryan
|
That is what hppens when you distort meal.What it did was shrunk in on your quarter when you streached uot the edge.As far as a fix without messin up paint?
1 Get a wooden mop handel and cut it off long enough to reach.
2 remove your trunk/hatch pannels
3 Check leangth make sure you can fit it in "its hella tight back there"
4 Tape some raggs on the rounded end and push slowly and easy
any harsh movements will distort the metal again.
Note:Next time start by streaching your fender out by usein a scissor jack w/a pice of wood in your inside wheel tub then jack then another paice of wood about 6 inches long on the insde of the outter edge.This will help by moving the metal out before you move it up thus not bucklein in.Thats how I did mine but Ive dont lots of body work.Its all by feel.Hope this helps.