Thread: Rear lower ball joint question
View Single Post
Old 03-25-2009, 10:14 PM   #37
cazman
 
cazman's Avatar
 
Join Date: Aug 2008
Location: SA
Age: 39
Posts: 22
Trader Rating: (0)
cazman is an unknown quantity at this point
Send a message via MSN to cazman
Quote:
Originally Posted by MELLO*SOS View Post
B13 joint work okay on the track IMO. But next time I do the rears I'll try the B12's out. I'm sure someone out there is putting off doing balljoints due to lack of a press? Go down to your checkers/oreilly/autozone and rent/borrow the balljoint toolkit... Takes only a few minutes to do each ball joint once u have the arms out... Impact wrench makes it go faster...


** FRONT S13 BALL JOINTS **
Just did front ball joints this past weekend, threw s13 bj's into s14 lca. Before I forget, the Moog PN is k9509.
** FRONT S13 BALL JOINTS **
S13 and S14 front ball joints are different, the ball joint taper is not the same.
It may look like the S14 one is doing up, but its not seating
cazman is offline   Reply With Quote