engine back in ready to mock up manifolds:
this is how far back I got it in the end without cutting the bulkhead.
strted fabing the new headers, got my stainless scraps together,
and made a small jig off the engine, then started to put
the jigsaw together.
L/H/S exhaust header.
R/H/S Exhaust header,
and the two together, there not 100% finished yet,
but ya get the jist. There the best I could do with the
restricted space I had to work with, espesialy on the
drivers side with the rack in the way and the fact there
made from left over scrap, anyway anything
has to flow better than the stock logs.
Stock logs:
and the new headers.
